Envoy 2WD V8-5.3L VIN M (2005)
Drive Belt: Testing and Inspection
Drive Belt Rumbling
Drive Belt Rumbling Diagnosis
Diagnostic Aids
Vibration from the engine operating may cause a body component or another part of the vehicle to make rumbling noise.
The drive belts may have a condition that can not be seen or felt. Sometimes replacing the drive belts may be the only repair for the symptom.
If after replacing the drive belts and completing the diagnostic table, the rumbling is only heard with the drive belts installed, there might be an
accessory drive component failure. Varying the load on the accessory drive components may aid in identifying which component is causing the
rumbling noise.
Test Description
The numbers below refer to the steps in the diagnostic table.
2. This test is to verify that the symptom is present during diagnosing. Other vehicle components may cause a similar symptom.
3. This test is to verify that the drive belts is causing the rumbling. Rumbling may be confused with an internal engine noise due to the similarity in
the description. Remove only one drive belt at a time if the vehicle has multiple drive belts. Operate the engine for a few seconds, this will verify if
the rumbling noise is related to the drive belts or not. With the drive belts removed the water pump will not operate and the engine may overheat.
Also diagnostic trouble codes (DTCs) may set when the engine is operated with the drive belts removed.
