Envoy 2WD V8-5.3L VIN M (2005)
Air Door Actuator / Motor: Service and Repair
HVAC System - Automatic
Air Temperature Actuator - Auxiliary
AIR TEMPERATURE ACTUATOR REPLACEMENT - AUXILIARY
REMOVAL PROCEDURE
1. Remove the right rear quarter trim panel.
2. Disconnect the electrical connector from the air temperature actuator.
3. Remove the retaining screws from the air temperature actuator.
4. Remove the air temperature actuator (1) from the rear HVAC module.
INSTALLATION PROCEDURE
1. Install the air temperature actuator (2) to the rear HVAC module.
2. Install the screws to the actuator.
Tighten the screws to 1.9 N.m (17 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the electrical connector to the air temperature actuator.
4. Recalibrate the air temperature actuator. Refer to Re-Calibrating Actuators (Primary).
5. Install the right rear quarter trim panel.
Air Temperature Actuator - Left
AIR TEMPERATURE ACTUATOR REPLACEMENT - LEFT
REMOVAL PROCEDURE
1. Remove the I/P carrier.