Envoy 2WD V8-5.3L VIN M (2005)
5. Install the console.
Recirculation Actuator
RECIRCULATION ACTUATOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the HVAC module assembly.
2. Remove the air inlet assembly.
3. Remove the screws from the air inlet assembly.
4. Remove the recirculation actuator screws.
5. Remove the recirculation actuator.
INSTALLATION PROCEDURE
1. Install the recirculation actuator.
2. Install the recirculation actuator screws.
Tighten the screws to 1.9 N.m (17 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the air inlet assembly.
4. Install the screws to the HVAC module assembly.
Tighten the screws to 1.9 N.m (17 lb in).
5. Install the HVAC module assembly.
6. Recalibrate the recirculation actuator on vehicles equipped with automatic climate control (C68). Refer to Re-Calibrating Actuators (Primary).