Envoy 2WD V8-5.3L VIN M (2005)
Center Mounted Brake Lamp: Service and Repair
High Mounted Stop Lamp Replacement
HIGH MOUNTED STOP LAMP REPLACEMENT
REMOVAL PROCEDURE
1. Open the liftgate.
2. Lower the rear portion of the headliner by releasing the 2 headliner retaining pins.
3. Disconnect the high mount stop lamp electrical connector (2).
4. Remove the grommet (1) from the body.
5. Close the liftgate.
NOTE: Do NOT raise the liftgate while the liftgate glass is open. This can result in damage to the high-mounted stoplamp, the liftgate hinges, or the
liftgate glass.
6. Open the liftgate window.
7. Remove the 2 screws that retain the high mount stoplamp to the lift gate window reveal molding.
8. Remove the high mount stop lamp from the vehicle.
INSTALLATION PROCEDURE
1. Install the high mount stop lamp to the lift gate window reveal molding, ensuring the center retaining tab is fully seated.
2. Install the 2 screws that retain the high mount stop lamp to the lift gate window reveal molding.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the 2 retaining screws to 2.5 N.m (22 lb in).
3. Close the liftgate window.
4. Open the liftgate.
