Envoy 2WD V8-5.3L VIN M (2005)
2.
Mask off the desired amount of material to be removed.
3.
Open the liftgate glass.
Note:
Do no damage the applique or the liftgate glass when removing the applique from the liftgate glass.
4.
Remove the screws that retain the applique to the liftgate glass.
5.
With a flat-bladed tool, carefully remove the applique from the liftgate glass.
6.
Remove the CHMSL harness grommet from the roof panel.
7.
Disconnect the CHMSL harness connector and remove CHMSL applique from the vehicle.
8.
Using a 1/4" die grinder and Scotch-Brite(R) Disc, 3M(R) P/N 07481, remove excess material from the applique.
9.
Paint the applique to match.
Important:
If the original part is used, it is important to seal (clear coat) the edge to protect the clear coat from lifting.
10.
Remove the old adhesive from the underside of the applique.
11.
Clean the application area of the CHMSL applique with Isopropyl Alcohol (rubbing alcohol), 3M(R) P/N 08984, or equivalent, and dry
thoroughly using a clean low lint towel or towelette.
12.
Apply double-sided adhesive tape, 3M(R) P/N 06397, or equivalent, to the underside of the CHMSL applique.
13.
Remove the old adhesive from the liftgate glass.
Important:
^
The installation area of the liftgate glass must be clean and dry. Any airborne dust, oils, etc., may contaminate the glass or the applique
adhesive, and reduce the bond of the tape.
^
DO NOT use commercial glass or surface cleaners. These may contain petroleum.
^
The glass surface temperature should be no lower than 21°C (70°F) and not exceed 38°C (100°F).
14.
Clean the application area of the liftgate glass with Isopropyl Alcohol (rubbing alcohol), 3M(R) P/N 08984, or equivalent, and dry thoroughly
using a clean low lint towel or towelette.
15.
Apply adhesive promoter, P/N 12378555, in Canada, use P/N 88901239, to the liftgate glass surface, completely wetting the applique application
