Envoy 2WD V8-5.3L VIN M (2005)
5. Press down and hold the locking tab (1).
6. Disengage the sliding latch retaining the BCM to the rear electrical center.Slide the latch inboard until fully extended, approximately 40 mm (1.6
in).
7. Disconnect the body wiring extension (1) from the BCM.
8. Disconnect the 32-way tan electrical connector (2) from the BCM.
9. Disconnect the 24-way gray electrical connector (1) from the BCM.
10. With an upward motion, disconnect the body wiring extension (1) from the rear electrical center.
11. Remove the body wiring extension from the vehicle.
INSTALLATION PROCEDURE
1. Using a downward motion, install the body wiring extension (1) to the rear electrical center.
IMPORTANT: Ensure the sliding latch is fully extended before connecting the body wiring extension to the rear electrical center.
