Envoy 2WD V8-5.3L VIN M (2005)
Tie Rod End: Service and Repair
Rack and Pinion Outer Tie Rod End Replacement
Tools Required
^
J24319-B Steering Linkage and Tie Rod Puller
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the outer tie rod retaining nut.
4. Notice: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result
which will cause premature failure of the joint.
Disconnect the outer tie rod from the steering knuckle using J24319-B.
5. Loosen the jam nut (1) and remove the outer tie rod (2) from the inner tie rod (3).Do not reuse the jam nut.
6. Inspect the shaft for bent or damaged threads.
7. Clean the tapered surface of the steering knuckle.
Installation Procedure
