Envoy 2WD V8-5.3L VIN P (2004)
Rear Door Window Glass Weatherstrip: Service and Repair
Door Window Channel
Window Weatherstrip Run Channel Assembly Replacement - Rear (TrailBlazer EXT, Envoy XL)
Window Weatherstrip Run Channel Assembly Replacement - Rear (TrailBlazer EXT, Envoy XL)
Removal Procedure
1. Remove the trim panel.
2. Remove the inner window belt sealing strip.
3. Remove the outer window belt sealing strip.
4. Remove the water deflector.
5. Remove the window regulator.
6. Carefully lower the glass into the door.
7. Remove the bolt (2) that retains the weatherstrip run channel to the door.
8. Pull the weatherstrip (1) loose from the window frame opening.
9. Release the clip retaining the quarter glass to the window opening by pulling forward on the run channel (4).
Important: The quarter glass and weatherstrip/run channel is not serviceable and should be replaced only as an assembly.
10. Remove the weatherstrip run channel assembly from the top of the door opening.
Installation Procedure
1. Install the weatherstrip/run channel assembly to the door.
2. Install the quarter glass into the window opening by pressing the window channel (4) rearward until the retaining clip is fully installed.
3. Press the weatherstrip (1) into the window frame opening.
4. Position the tabs on the weatherstrip into the slots on the door.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the weatherstrip/run channel retaining bolt.
Tighten the bolt to 10 N.m (88 lb in).
6. Install the window glass into the run channel, slide up to the closed position, tape the window to the door frame.
