Envoy 2WD V8-5.3L VIN P (2004)
Trunk / Liftgate Shock / Support: Service and Repair
Strut Replacement - Liftgate
Strut Replacement - Liftgate
Removal Procedure
Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the
vehicle or personal injury.
1. Open and support the liftgate.
Notice: Refer to Liftgate/Hood Assist Rod Notice in Service Precautions.
2. Lift up the retainer clips on the liftgate struts using a small flat-bladed tool.
3. Remove the upper end of the liftgate struts from the ball joint.
4. Remove the lower end of the liftgate struts from the ball joint.
5. Remove the liftgate struts from the liftgate.
Installation Procedure
1. Position the liftgate struts to the liftgate.
2. Install the upper end of the liftgate struts to the ball joint. Press in to place until fully seated.
3. Install the lower end of the liftgate struts to the ball joint. Press in to place until fully seated.
4. Remove the support device from the liftgate.
5. Close the liftgate.