Envoy 2WD V8-5.3L VIN P (2004)
License Plate Bracket: Service and Repair
License Plate Pocket Replacement (All Except Envoy XUV)
License Plate Pocket Replacement (All Except Envoy XUV)
Removal Procedure
1. Remove the license pocket lamps.
2. Remove the lift gate trim panel.
3. Disconnect the bellcrank rod from the outside door release handle.
4. Remove the screws that retain the license pocket to the lift gate.
5. Remove the license pocket from the lift gate.
6. Remove the lift gate handle from the license plate pocket.
Installation Procedure
1. Install the lift gate handle to the license plate pocket.
2. Install the panel to the lift gate.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the screws that retain the panel to the lift gate, starting with the bottom center screw first.
Tighten the screws to 5 N.m (44 lb in).
