Envoy 2WD V8-5.3L VIN P (2004)
Rear Fender Liner: Service and Repair
Wheelhouse Panel Replacement
Removal Procedure
1. Remove the bolt that retains the wheelhouse panel to the rocker panel molding.
2. Remove the 2 screws that retain the wheelhouse panel to the rear fascia.
3. Remove the 4 push-pins retaining the wheelhouse panel to the wheelhouse.
4. Remove the wheelhouse panel from the vehicle.
Installation Procedure
1. Install the wheelhouse panel to the vehicle.
2. Install the 4 push-pins retaining the panel to the wheelhouse.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the 2 screws that retain the wheelhouse panel to the rear fascia.
Tighten the 2 screw to 2 N.m (18 lb in).
4. Install the bolt that retains the wheelhouse panel to the rocker panel molding.
Tighten the bolt to 7 N.m (62 lb in).
