Envoy 2WD V8-5.3L VIN P (2004)
Caution: In order to avoid personal injury or vehicle damage when you repair or replace the carpet, use the same thickness and material
size as the original installation. Always return the carpet to the original location.
1. Position the carpet to the floor panel.
2. Raise the rear portion of the floor console bracket and slide the carpet underneath the console bracket.
3. Position the rear carpet over the edge of the front carpet.
4. Align the holes in the carpet to the seat studs on the floor panel.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the four nuts retaining the rear of the floor console bracket to the floor weld studs.
Tighten the nuts to 25 N.m (18 lb ft).
6. Feed the bussed electrical center base and the communication interface module electrical connectors through the pass through holes in the carpet.
7. Install the floor console.
8. Install the child restraint tether anchors.
9. Install the bussed electrical center.
10. Install the tool kit carrier.
11. Install the 3 tool carrier nuts to the floor studs.
Tighten the nuts to 7 N.m (62 lb in).
12. Install the lower rear quarter trim panels.
13. Install the center pillar trim panels.
14. Install the lift gate door sill plate.
15. Install the rear door sill plates.
16. Install the front door sill plates.
17. Install the front bucket seats.
18. Instal the seat back, right and left side.
19. Install the navigation control processor bracket to the floor panel.
20. Install the rear seat cushions.
21. Install the communication interface module.
22. Install the front seats.
Carpet Replacement - Rear (Envoy XUV)
Carpet Replacement - Rear (Envoy XUV)
Removal Procedure
