Envoy 2WD V8-5.3L VIN P (2004)
1. Remove the key from the ignition.
2. Connect the side impact sensor yellow 2-way connector (5) located near the bottom left of the door.
3. Install the CPA (3) to the side impact sensor yellow 2-way connector (5) located near the bottom left of the door.
4. Install the LF door trim panel.
5. Install the SIR fuse to the fuse block (1) located in the underhood fuse block.
6. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
6.1.
The AIR BAG indicator will flash 7 times.
6.2.
The AIR BAG indicator will then turn OFF.
7. Perform the Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.
SIR Disabling and Enabling Zone 3
SIR DISABLING AND ENABLING ZONE 3
DISABLING PROCEDURE
IMPORTANT: Refer to SIR Disabling and Enabling Zones before disabling the SIR system.
