Envoy 2WD V8-5.3L VIN P (2004)
Installation Procedure
1. Position the trim panel to the vehicle.
2. Position the seat belt over the top of the trim panel, ensuring that the buckle is not behind the trim panel.
3. Index the locating tabs on the trim panel to the holes in the body.
4. Connect the wiring harness connector to the auxiliary power outlet.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the five screws that the retain the rear quarter trim panel to the body.
Tighten the rear quarter trim panel screws to 2.5 N.m (22 lb in).
6. Install the seat belt lower anchor.
Tighten the seat belt anchor bolt to 70 N.m (52 lb ft).
7. Install the right rear door sill panel.
8. Install the liftgate sill plate.
9. Install the right body side window forward garnish molding.
10. Install the right body side window rear garnish molding.
11. Return the third row seats to the upright position.
12. Install the cargo shelf.
Trim Panel Replacement - Rear Quarter - Right (TrailBlazer, Envoy, Bravada)
Trim Panel Replacement - Rear Quarter - Right (TrailBlazer, Envoy, Bravada)
Removal Procedure
1. Remove the cargo shade/cover.
2. Remove the inflator access panel.
3. Remove the right rear quarter upper trim panel.
4. Remove the lift gate sill plate.
5. Remove the right rear door sill panel.
6. Remove the lower seat belt anchor bolt.
7. Release the retaining clips that retain the trim panel to the body.
