Envoy 2WD V8-5.3L VIN P (2004)
7. Carefully separate the hook and loop fastener strips (2) holding the cover to the pad.
8. Remove the hog rings (1).
Installation Procedure
1. Install the hog rings (1) securing the seat cover to the pad.
2. Pull the cover over the pad pressing the hook and loop fastener strips (2) together.
3. Install the cover flaps to the pad with hog rings (1).
4. Install the seat cushion panel on the pad and cover.
5. Install the J-strips (2) securing the seat cushion cover to the seat cushion panel.
6. Install the pull handle assembly (1).
Notice: Refer to Fastener Notice in Service Precautions.
7. Install the rear seat cushion assembly (1) to the seat latch rod (3) with two bolts (2).
