Envoy 2WD V8-5.3L VIN P (2004)
3. Install the hydraulic jack into the jack stowage area, on the left side only.
4. Adjust the seat cushion assembly to the latched position.
5. Install the rear mount trim cover.
Seat Cushion Bracket Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)
Seat Cushion Bracket Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)
Removal Procedure
1. Remove the rear seat cushion assembly from the vehicle.
2. Remove the 2 bolts securing the bracket assembly to the seat cushion.
3. Remove the bracket assembly from the seat cushion.
Installation Procedure
1. Position the bracket assembly on the seat cushion.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the 2 bolts securing the bracket assembly to the seat cushion.
Tighten the rear seat cushion bracket bolts to 25 N.m (18 lb ft).
