Envoy 2WD V8-5.3L VIN P (2004)
Installation Procedure
1. Install the handle(s) to the end gate.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the screws retaining the handle(s) to the license plate pocket.
Tighten the screws to 2.5 N.m (22 lb in).
3. Connect the electrical connector (2) to the end gate handle(s).
4. Install the inner panel reinforcement.
5. Install the rear body control module.
6. Install the trim panel to the end gate.
