Envoy 2WD V8-5.3L VIN P (2004)
area.
Important:
^
Use a clean low lint towel or towelette and wipe the glass, only removing the excess adhesive promoter from the lift gate glass.
^
Do not wipe the glass dry.
^
Allow the liftgate glass to air dry completely.
^
The applique must be installed within 30 minutes following the use of the promoter.
16.
Allow the adhesive promoter to remain on the glass surface for a minimum of 10 seconds.
17.
Attach the CHMSL wire to the connector and install the grommet.
18.
Slide the liftgate glass on the hinge pins to the left in order to allow clearance for the locating hooks.
19.
Remove the protective liner from the tape on the applique.
20.
Attach the locating hooks on the applique to the hinge pins.
21.
Apply the applique to the liftgate glass.
22.
With the heel of your hand, and starting from center of the applique and working outward towards each outer edge, apply even and consistent
pressure ensuring complete contact of the adhesive strip to the glass.
23.
Install the screws that retain the applique to the liftgate glass.
Tighten
Tighten the screws to 5 N.m (44 lb in).
Important:
The vehicle must be kept dry and at 21°C (70°F) to 43°C (110°F) for no less than 4 hours to ensure proper adhesive cure time.
24.
Clean the liftgate glass and applique area.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
