Envoy 2WD V8-5.3L VIN P (2004)
10. Install the SIR fuse to the fuse block (1) located in the underhood electrical center.
11. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
11.1. The AIR BAG indicator will flash 7 times.
11.2. The AIR BAG indicator will then turn OFF.
12. Perform the Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.
SIR Disabling and Enabling Zone 9
SIR DISABLING AND ENABLING ZONE 9
DISABLING PROCEDURE
IMPORTANT: Refer to SIR Disabling and Enabling Zones before disabling the SIR system.
1. Turn the steering wheel until the vehicle's wheels are pointing straight ahead.
2. Turn OFF the ignition.
3. Remove the key from the ignition.
IMPORTANT: With the SIR fuse removed and the ignition ON, the AIR BAG indicator illuminates.This is normal operation and does not indicate
an SIR system malfunction.
4. Remove the SIR fuse from the fuse block (1) located in the underhood fuse block.
5. Remove the CPA from the RF side impact module yellow 2-way connector (1) located under the passenger seat.
6. Disconnect the RF side impact module yellow 2-way connector (1) located under the passenger seat.
ENABLING PROCEDURE
