Envoy 2WD V8-5.3L VIN P (2004)
7. Disconnect the body wiring extension (1) from the BCM.
8. Disconnect the 32-way tan electrical connector (2) from the BCM.
9. Disconnect the 24-way gray electrical connector (1) from the BCM.
10. With an upward motion, disconnect the body wiring extension (1) from the rear electrical center.
11. Remove the body wiring extension from the vehicle.
INSTALLATION PROCEDURE
1. Using a downward motion, install the body wiring extension (1) to the rear electrical center.
IMPORTANT: Ensure the sliding latch is fully extended before connecting the body wiring extension to the rear electrical center.
2. Connect the 24-way gray electrical connector (1) to the BCM.