Envoy 2WD V8-5.3L VIN P (2004)
3. Install the mounting bolt behind the accelerator pedal.
Tighten
Tighten the mounting nuts to 11 N.m (97 lb in).
IMPORTANT: The following procedure must be performed before if the accelerator pedal or brake pedal drive motor and cable assembly are being
replaced. Failure to do so could cause an IMPROPER STEP OVER HEIGHT.
4. Adjust the accelerator pedal in the following sequence:
4.1.
Turning the motor transmission clockwise reduces the gap, and counterclockwise increases the gap.
4.2.
Position the drill bit 4.5 N.m (0.187 in-3/16 or the equivalent in number and or letter drill bits) a 1/4 of an inch from the bottom of the metal
accelerator pivot arm.
4.3.
Rotating the drive cable by hand, adjust the accelerator motor transmission until the drill 4.5 N.m (0.187 in-3116 or the equivalent in
number and or letter drill) bit fits snugly between the plastic accelerator arm and the metal pivot arm.
