Envoy 2WD V8-5.3L VIN P (2004)
3. Connect the 32-way tan electrical connector (2) to the BCM.
4. Connect the body wiring extension (1) to the BCM.
5. Engage the sliding latch fastening the BCM to the rear electrical center. Slide the latch outboard until the locking tab (1) is fully seated.
6. Install the rear electrical center cover.
7. If replacing the body wiring extension for the ascender short wheelbase, position the left hand second seat to a passenger position.
8. If replacing the body wiring extension for the ascender long wheel base, install the left second row seat.
9. Connect the negative battery cable.
Module Rear Body Control Replacement - Endgate
Module Rear Body Control Replacement - Endgate
Removal Procedure
1. Remove the trim panel from the end gate.
