gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

4X4 System - Service 4WD Lamp ON/4WD Inoperative|Page 3994 > < 4X4 System - Service 4WD Lamp ON/4WD Inoperative|Page 3992
Page 3
background image

For vehicles repaired under warranty, use the table.

Disclaimer

Technical Service Bulletin # 04-04-19-001

Date: 040223

4X4 System - Service 4WD Lamp ON/4WD Inoperative

Bulletin No.: 04-04-19-001

Date: February 23, 2004

TECHNICAL

Subject:
Diagnostic Trouble Code (DTC) C0379 Set, Service 4WD Light On, 4WD Inoperative (Replace Front Axle Actuator)

Models:
2004 Chevrolet TrailBlazer, TrailBlazer EXT
2004 GMC Envoy, Envoy XL, Envoy XUV
with Autotrac Active Transfer Case (RPO NP8)

Condition

Some customers may comment that the Service 4WD light is on and/or the 4WD system will not engage. This condition may only occur after a cold
temperature start-up (typically below -6°C to -1°C (20°F to 30°F).

Cause

If this concern is accompanied by an illuminated Service 4WD light, and a DTC C0379, during a cold weather start up, the following information may
apply.

The front drive axle actuator assembly engages the front axle in response to commands from the Transfer Case Control Module (TCCM). Normally, the
cycle time for engagement is under 3 seconds, regardless of temperature. If the actuator does not engage the front axle assembly within 10 seconds, the
TCCM sets DTC C0379, illuminates the Service 4WD light and disables the 4WD system. There have been reports of vehicles with front drive axle
actuator assemblies that take longer than 10 seconds to engage, setting this code.

Correction

Important:

When a vehicle with this concern is diagnosed in the repair facility, usually the inside temperature is warm enough that the system operates normally,
and the C0379 will be set as a history code, making the concern intermittent and difficult to diagnose.

4X4 System - Service 4WD Lamp ON/4WD Inoperative|Page 3994 > < 4X4 System - Service 4WD Lamp ON/4WD Inoperative|Page 3992