Envoy 2WD V8-5.3L VIN P (2004)
5. Remove the bolt that retains the rear seat belt retractor assembly to the body.
6. Remove the rear seat belt retractor assembly from the vehicle.
INSTALLATION PROCEDURE
1. Position the rear seat belt retractor assembly to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the bolts which retain the rear seat belt retractor assembly to the body.
Tighten
Tighten the rear seat belt retractor bolts to 70 N.m (52 lb ft).
3. Install the upper body look pillar trim panel.