Envoy 2WD V8-5.3L VIN P (2004)
6. Place the larger cylinder line (2) into the valve housing (3).
Important: Hold the larger cylinder line (2) in place. Do not torque the cylinder line nut (1).
7. Place the other end of the cylinder line at the gear tube end (4).
Finger tighten the cylinder line nut (1) on the larger cylinder line.
8. Place the cylinder line retaining plate (2) over the cylinder line beads at the valve end.
Notice: Refer to Fastener Notice in Service Precautions.
9. Install the TORX screw (1) into the cylinder line retaining plate (2) and tighten using an E 8 socket.
Tighten the screw to 15 Nm (12 ft. lbs.).
10. Tighten both cylinder line nuts (3) at the cylinder end.
Tighten the nuts to 31 Nm (23 ft. lbs.).
