Envoy 2WD V8-5.3L VIN P (2004)
10. Remove the air spring level sensor to the frame mounting bolts.
11. Remove the air spring level sensor.
Installation Procedure
1. Install the air spring level sensor link to the upper control arm.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Do not remove the air spring level sensor locating pin until the air spring level sensor has been properly aligned and the proper D height
has been measured and maintained.
2. Install the air spring level sensor to the frame mounting bolts.
Tighten the air spring level sensor to the frame mounting bolts to 8 Nm (6 lb ft).
