Envoy 2WD V8-5.3L VIN P (2004)
8. Install the transmission fluid pressure switch.
9. Install but do not tighten the control valve body bolts which retain the transmission fluid pressure switch to the control valve body.
Notice: Refer to Fastener Notice in Cautions and Notices.
Notice: Torque valve body bolts in a spiral pattern starting from the center. If the bolts are torqued at random, valve bores may be distorted and
inhibit valve operation.
10. Tighten the control valve body bolts in a spiral pattern starting from the center, as indicated by the arrows.
^
Tighten the control valve body bolts (in sequence) to 11 Nm (97 inch lbs.).
11. Ensure that the manual detent spring is aligned properly with the detent lever.
^
Tighten the manual detent spring bolt to 31 Nm (23 ft. lbs.).
