Envoy 2WD V8-5.3L VIN P (2004)
Installation Procedure
1. Install the splash shield to the steering knuckle. Align the splash shield to the steering knuckle threaded holes.
2. Install the wheel hub and bearing to the steering knuckle. Align the threaded holes.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the wheel hub and bearing to the steering knuckle mounting bolts.
Tighten the wheel hub and bearing mounting bolts to 105 Nm (77 ft. lbs.).
4. Install the ABS sensor to the wheel hub and bearing.
5. Install the ABS sensor mounting bolt to the wheel hub and bearing.
Tighten the ABS sensor to the wheel hub and bearing mounting bolt to 18 Nm (13 ft. lbs.).
6. Install the brake rotor.
7. Install the tire and wheel.
