Envoy 4WD L6-4.2L VIN S (2003)
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the bolt to 3.75 N.m (33 lb in).
7.2.
Install the EVAP/fuel hose/pipe assembly into the clip at the rear of the transmission.
8. Use the following procedure with four wheel drive (4WD):
8.1.
Position the fuel EVAP/fuel hose/pipe assembly against the transmission and install the retaining bolt (3) through the EVAP/fuel hose/pipe
assembly strap into the transmission.
Tighten
Tighten the bolt to 3.75 N.m (33 lb in).
8.2.
Install the EVAP/fuel hose/pipe assembly into the clip at the rear of the transmission.
9. Install the EVAP/fuel hose/pipe assembly (4) into the EVAP/fuel hose/pipe assembly clip at the rear of the engine.
10. Connect the integral clip (3) to the engine bracket.
11. Connect the EVAP purge pipe (5) to the EVAP canister purge valve.
12. Lower the vehicle.
13. Connect the fuel feed (1) and fuel return (2) pipes to the fuel rail.
14. Connect the powertrain control module connectors to the powertrain control module.
15. Connect the negative battery cable.
16. Inspect for leaks using the following procedure:
16.1. Turn ON the ignition, with the engine OFF for 2 seconds.
16.2. Turn OFF the ignition, for 10 seconds.
16.3. Turn ON the ignition, with the engine OFF.
