Envoy 4WD V6-4.3L VIN W (1998)
13. Remove and discard the seals.
14. Clean all of the components in a suitable solvent, and dry them with compressed air.
15. Inspect the fittings, the connectors, the cooler lines, the cooler, the filter lines, and the remote filter adapter for damage, distortion, or restriction.
Replace parts as necessary.
16. Flush the engine oil cooler, the engine oil cooler lines, engine oil filter adapter, and the remote engine oil filter lines with the same type of engine
oil normally circulating through the engine.
INSTALLATION PROCEDURE
1. Install new seals on both ends of each remote engine oil filter line.
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Install the bolt attaching the remote engine oil filter lines to the remote engine oil filter lines (engine mounted) adapter.
^
Tighten the bolt to 35 Nm (26 ft. lbs.).
3. Install the bolt attaching the remote engine oil filter lines to the remote (frame mounted) engine oil filter adapter.
^
Tighten the bolt to 35 Nm (26 ft. lbs.).
4. Install the remote engine oil filter lines support clamp bolt.
^
Tighten the bolt to 10 Nm (89 inch lbs.).
