Envoy 4WD V6-4.3L VIN W (1998)
9. Remove the rivets using a pin punch.
10. Remove the ball joint.
INSTALLATION PROCEDURE
1. Install the ball joint to the upper control arm.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
2. Install the bolts and the nuts to the ball joint.
Tighten
Tighten the nuts to 23 Nm (17 ft. lbs.).
3. Install the ball joint to the knuckle.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
4. Install the upper ball joint to steering knuckle nut.
Tighten
^
Tighten the nut in order to align the cotter pin. Do not tighten the nut more than 1/6 turn.
