gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

ABOUT US
A/T - Revised Converter Check Valve/Cooler Line Fitting|Page 6906 > < A/T - Revised Converter Check Valve/Cooler Line Fitting|Page 6904

Envoy 4WD V6-4.3L VIN W (1998)

Page 1
background image

Fluid Line/Hose: Service and Repair

REMOVAL PROCEDURE 

1. Raise the vehicle. Support the vehicle.
2. Remove the two oil cooler lines from the radiator.

3. Pull the plastic cap back from the quick connect fitting and down along the cooler line about two inches.

IMPORTANT:  Perform the following procedures when removing the retaining ring and cooler line from the quick connect fitting on the
transmission.

4. Using a bent-tip screwdriver, pull on one of the open ends of the retaining ring in order to rotate the retaining ring around the quick connect fitting

until the retaining ring is out of position and can be completely removed.

A/T - Revised Converter Check Valve/Cooler Line Fitting|Page 6906 > < A/T - Revised Converter Check Valve/Cooler Line Fitting|Page 6904