Envoy 4WD V6-4.3L VIN W (1998)
1. Install the axle into the vehicle using the hoist.
2. Connect the vent hose to the axle housing.
3. Install the U-bolts and the anchor plates.
4. Install the nuts and the washers.
^
Tighten the nuts to 100 Nm (74 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
5. Connect the brake pipes to the backing plate.
6. Connect the park brake cable(s).
7. Install the brake pipes at the axle housing.
8. Bleed the brake system.
9. Line up the previously made marks on the propeller shaft with the marks on the pinion flange. Install the propeller shaft.
10. Install the retainers and the bolts to the pinion flange.
^
Tighten the bolts to 45 Nm (33 ft. lbs.).
