Envoy 4WD V6-4.3L VIN W (1998)
6. Place the top half of the J 41048 on the bottom half.
7. Check to make sure there are no pinch points on the boot before proceeding.
8. Insert the bolts (2).
9. Tighten the bolts (2) by hand until snug.
10. Align the following items:
^
The boot
^
The housing
^
The swage clamp
-
Tighten Each bolt 180 degrees at a time, using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
11. Loosen the bolts.
12. Separate the dies.
13. Check the swage clamp for any "lip" deformities.
IMPORTANT: If deformities exist in the swage clamp, place the swage clamp back into J 41048. Ensure the swage clamp covers the whole
swaging area. Re-swage the swage clamp.
14. Install the convolute retainer over the boot capturing four convolutions.
IMPORTANT: Assemble the joint with the convolute retainer in the correct position. Assemble the joint to meet the specified dimension to
avoid boot damage.
