Envoy 4WD V6-4.3L VIN W (1998)
28. Slide the large diameter of the CV joint boot (1), with the large retaining ring (2) in place, over the outside edge of the CV joint outer race (3).
29. Position the lip of the CV joint boot (1) into the groove on the CV joint outer race (3).
30. Manipulate the CV joint boot (1) to remove any excess air.
31. Secure the large retaining clamp (1) this replaces the swage ring and the boot to the housing with J 35910 (or equivalent), a breaker bar (3), and a
torque wrench (2).
^
Torque the large retaining clamp (1) to 76 Nm (130 ft. lbs.).
32. Check the gap dimension on the clamp ear.
33. Install the boot clamp protectors (if used) over the large retaining clamp.
