Envoy 4WD V6-4.3L VIN W (1998)
Windshield Washer Reservoir: Service and Repair
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
2. Remove the washer solvent.
3. Disconnect the electrical connector from the washer pump.
4. Disconnect the washer hose assembly from the washer pump.
5. Remove the mounting screw retaining the solvent container to the vehicle.
6. Remove the air filter housing, it necessary. Slide the air filter housing up, in order to remove the housing.
7. Remove the solvent container from the vehicle.
8. Remove the washer pump from the container.
INSTALLATION PROCEDURE
IMPORTANT: Push the washer pump as far into the container seal as possible.
1. Connect the washer pump to the container.
2. Insert the solvent container legs into the holes in the inner fender.
3. Install the mounting screw retaining the solvent container to the vehicle.
Tighten
Tighten the screw to 3 N.m (27 lb in)
4. Connect the washer hose assembly from the washer pump.
5. Connect the electrical connector to the washer pump.
6. Replace the washer solvent.
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
7. Connect the negative battery cable.
