Envoy 4WD V8-5.3L (2007)
Driver/Vehicle Information Display: Description and Operation
Driver Information Center (DIC) Description and Operation
Driver Information Center (DIC)
The driver information center (DIC) consists of a single line 22 character vacuum fluorescent (VF) display placed in the lower center area of the
instrument panel cluster (IPC). The DIC will display vehicle information, configuration, and warning parameters to the driver.
The display parameters are cycled, changed, and acknowledged using four (4) DIC buttons.
*
Trip Information
Button representation icon appears as a road to the horizon.
*
Fuel Information
Button representation icon appears as a gasoline pump.
*
Personalization
Button representation icon appears as a human next to vehicle.
*
Select
Button representation icon appears as an arrow.
DIC Displays
The DIC parameters are displayed by order of priority as follows (from highest to lowest) :
*
Service Diagnostics
*
Driver Identifier
*
Feature Programming
*
Driver Warnings
*
Vehicle Information
Vehicle Information
Vehicle information provides feedback to the driver on vehicle performance, mileage, maintenance, or related information.
Vehicle information can only be displayed with the ignition switch in the RUN position.
When the English/Metric status changes, any applicable vehicle information data values will also change.
DIC Trip Information / Reset Capabilities
The available DIC Trip Information and reset capabilities are as follows:
*
Odometer - Cannot be reset
*
Trip Odometer A - Can be reset
*
Trip Odometer B - Can be reset
*
Timer - Can be reset
*
Tire Pressures
Trip Reset Stem/Trip Information
The trip reset stem on the IPC operates in the following manner with the ignition switch in the RUN position:
1. Each time the reset stem or the DIC Trip Information button is pushed the display will cycle to the next trip parameter. The trip parameters are as
follows:
*
Odometer
*
Trip A odometer
*
Trip B odometer
2. Holding the reset stem for greater than 4 seconds or depressing the Trip Information button for greater than one second while either Trip A or
Trip B odometer is displayed will reset the displayed trip odometer to 0.0 upon release of the stem. The trip odometer will remain displayed after
being reset.
3. If a trip odometer parameter is being displayed, pressing the Trip Information button will display the next trip odometer parameter.
4. If the next Trip Information parameter to be displayed is Timer or blank, pressing the reset stem will return the display to the Odometer.
Odometer
