Envoy 4WD V8-5.3L (2007)
6. Install the NEW copper gaskets on the brake hose bolt.
7. Remove the plug from the brake hose end.
8. Install the brake hose bolt on the rear brake caliper.
Tighten the brake hose bolt to 40 N.m (30 lb ft).
9. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure).
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
11. Lower the vehicle. Refer to Lifting and Jacking the Vehicle.
