Envoy 4WD V8-5.3L (2007)
7. Remove the rear brake caliper mounting bracket.
8. Remove the brake rotor retaining clips, if equipped.
9. If the brake rotor is stuck, perform the following:
1. Assemble J-46277 to J 2619-01
2. Insert J-46277 between the rotor friction surfaces in the vent section of the rotor. DO NOT place the J-46277 on the rotor friction surface.
3. Using the J-46277 and J 2619-01 release the rotor from the hub assembly.
Notice: Whenever the rotor has been separated from the axle flange, clean any rust or foreign material from the mating surface of the axle flange
and brake rotor. Failure to do this may result in increased lateral runout of the rotor and brake pulsation.
Important: If the brake rotor is not going to be replaced but just removed from the front hub to be refinished, mark the brake rotor left
or right and the relationship of the brake rotor and a wheel stud. In doing so, it will reduce the possibility of vibration in the brake
system.
10. Remove the brake rotor.
