Envoy 4WD V8-5.3L (2007)
3. Install the oil pan-to-rear cover bolts (1) until snug. Do not over tighten.
4. Rotate the crankshaft until 2 opposing flywheel bolt holes are parallel to the oil pan surface.
Important: The tapered legs of the alignment tool must enter the rear cover oil seal bore.
5. Install J 41476 and bolts onto the rear of the crankshaft.
Notice: Refer to Fastener Notice.
6. Tighten J 41476 mounting bolts until snug. Do not overtighten.
1. Tighten the oil pan-to-rear cover bolts to 12 N.m (106 lb in).
2. Tighten the engine rear cover bolts to 30 N.m (22 lb ft).
7. Remove J 41476.
8. Install a NEW crankshaft rear oil seal. Refer to Crankshaft Rear Oil Seal Replacement.
9. Install the engine flywheel. Refer to Engine Flywheel Replacement.