Envoy 4WD V8-5.3L (2007)
1. Install the defroster actuator.
Notice: Refer to Fastener Notice.
2. Install the defroster actuator screws.
Tighten the screws to 1.9 N.m (17 lb in).
3. Connect the electrical connector to the defroster actuator.
4. Install the I/P carrier.
Mode Actuator Replacement
Mode Actuator Replacement
Removal Procedure
1. Remove the left side sound insulator screws.
2. Remove the left hand floor duct.
3. Disconnect the electrical connector from the mode actuator.
4. Remove the screws from the mode actuator (1).
5. Remove the mode actuator.
Installation Procedure