Envoy 4WD V8-5.3L (2007)
15. Finish removing the starter from the vehicle.
Installation Procedure
1. Begin installing the starter between the transmission oil cooler lines and the engine oil pan.
2. Install the battery positive cable (1) to the starter stud.
Notice: Refer to Fastener Notice.
3. Install the battery positive cable nut (2).
Tighten the nut to 9 N.m (80 lb in).
4. Install the starter solenoid lead (1) to the solenoid stud.
5. Install the starter solenoid nut (2).
Tighten the nut to 3.4 N.m (30 lb in).
6. Install the starter solenoid heat shield.
