Envoy 4WD V8-5.3L (2007)
7. Disconnect the power steering pressure (1) and return hose (3) from the power steering pump (2).
8. Remove the engine control module (ECM) from the ECM mounting bracket and position the ECM out of the way. Refer to Engine Control
Module Replacement.
9. Remove the power steering hose assembly (1) front bracket mounting bolt (3) from the frame.
10. Remove the power steering pressure hose from the retaining clip.
11. Remove the power steering hose assembly rear bracket mounting bolt (2).
12. Remove the power steering hose assembly from the vehicle.
13. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Notice: Clean the power steering gear inlet and outlet ports thoroughly of any debris. Failure to do so could result in contamination and damage to
the power steering system components.
14. Install the seal extraction end of the J 44586 (2) to the power steering gear oil seal (1).
