Envoy 4WD V8-5.3L (2007)
Transfer Case Rear Output Shaft Speed Sensor Replacement - Right Side
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the transfer case right rear speed sensor electrical connector.
3. Remove the transfer case right rear speed sensor.
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the transfer case right rear speed sensor.
Tighten the sensor to 17 N.m (13 lb ft).
2. Install the transfer case right rear speed sensor electrical connector.
3. Lower the vehicle. Refer to Lifting and Jacking the Vehicle.