Envoy 4WD V8-5.3L (2007)
Notice: Refer to Fastener Notice.
7. Install motor/encoder mounting bolts to the transfer case.
Tighten the bolts to 16 N.m (12 lb ft).
8. Connect the motor/encoder electrical connector (1).
9. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement.
10. Lower the vehicle. Refer to Lifting and Jacking the Vehicle.
Transfer Case Motor/Encoder Replacement (TrailBlazer, Envoy, Rainier)
Transfer Case Motor/Encoder Replacement (TrailBlazer, Envoy, Rainier)
Removal Procedure
Important: Before the motor/encoder is removed, ensure that the motor/encoder is in the 2HI position.
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the fuel tank shield, if equipped. Refer to Fuel Tank Shield Replacement (TrailBlazer EXT, Envoy XL) Fuel Tank Shield Replacement
(TrailBlazer, Envoy).
