Envoy 4WD V8-5.3L VIN M (2005)
Do not use oxyacetylene welding equipment. MIG WELD ONLY.
Weld the crack/four holes that were drilled through the inner panel using the appropriate welding technique.
Prior to refinishing, refer to the GM4901M-D-2006 (English) or GM4901M-D-F2006 (French) GM Approved Refinish Materials booklet for
recommended products. The GM Refinish Materials information is now on the GMGOODWRENCH WEB SITE ONLY. Printed books have been
discontinued. Steps to the site are as follows:
Go to www.gmgoodwrench.com.
Click on GM Parts and Accessories link.
Click on GM Technical Repair Information.
Click on Paint Shop.
Clean and prepare all of the welding surfaces.
Return the surface to its original contour.
Spot paint and clear the area around the hinges.
Reinstall the liftgate.
Replace the upper two bumpers and inspect the lower two bumpers. Replace as necessary.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer
