Envoy 4WD V8-5.3L VIN M (2005)
Remove the auxiliary seal and the auxiliary seal retainer. Clean the surface and fill the void with Medium Body Seam Sealer, P/N 12378500 (in Canada,
P/N 10952233). Let stand for 60 minutes and touch up.
Correction 2
Remove the auxiliary seal and the auxiliary seal retainer. Clean the area with a non oil base cleaner and fill the void with urethane sealer.
Correction 3
Install four new plastic nuts in the "A" Pillar. The new nuts have a foam gasket that seals the perimeter when seated.
Correction 4
Seat the push-in retainers fully at the bottom of the "A" pillar.
Correction 5
Apply weatherstrip adhesive inside the primary seal retainer. Seal the retainer from the top of the dash to the bottom of the "A" pillar.
Parts Information
Warranty Information (excluding Saab U.S. Models)
For vehicles repaired under warranty, use the table.
Warranty Information (Saab U.S. Models)
For vehicles repaired under warranty, use the table.
Disclaimer
