Envoy 4WD V8-5.3L VIN M (2005)
11. Connect the coax cable (1) to the navigation antenna, if equipped.
12. Connect the rain sensor electrical connector (2), if equipped.
13. Connect the inside rear view mirror electrical connector (3).
14. Install the windshield rearview mirror wire harness cover.
15. Install the video display, if equipped.
16. If equipped, install the overhead console.
17. Install the windshield garnish moldings.
18. Install the center pillar trim panels.
19. Install the front side door sill plates.
20. Install the right sound insulator.
21. Install the headliner harness to the left third pillar.
22. Install the headliner harness to the floor studs.
23. Install the ground terminals and the ground bolt to the left center pillar.
Tighten the ground bolt to 10 N.m (88 lb in).
24. Reach underneath the carpet and install the 6-way headliner harness electrical connector (1) to the cross-body wire harness.
25. Pass the communication interface module electrical connectors through the small hole in the carpet.
26. Install the headliner harness retaining clips to the rocker panel and the floor panel.
