Envoy 4WD V8-5.3L VIN M (2005)
4. Install the seat cushion panel on the pad and cover.
5. Install the J-strips (2) securing the seat cushion cover to the seat cushion panel.
6. Install the pull handle assembly (1).
Notice: Refer to Fastener Notice in Service Precautions.
7. Install the rear seat cushion assembly (1) to the seat latch rod (3) with two bolts (2).
Tighten the seat cushion bolts to 11 N.m (97 lb in).
Seat Cushion Frame Replacement - Front
Seat Cushion Frame Replacement - Front
Removal Procedure
1. Remove the 3 seat switch bezel mounting screws.
2. Remove the 4 nuts that secure the seat pan to the power seat adjuster frame.
3. Remove the clip from the front outboard seat pan stud, if equipped. Discard the clip.
4. Disconnect the black electrical connector (6) from the seat back harness.
