Envoy 4WD V8-5.3L VIN M (2005)
3. Install the garnish molding.
4. Connect the side impact sensor yellow 2-way connector (5) located near the middle of the door.
5. Install the CPA (3) to the side impact sensor yellow 2-way connector (5) located near the middle of the door.
6. Install the right door trim panel.
7. Install the SIR fuse to the fuse block (1) located in the underhood fuse block.
8. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
1. The AIR BAG indicator will flash 7 times.
2. The AIR BAG indicator will then turn OFF.
9. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information, if the AIR BAG indicator does not operate as described.
SIR Disabling and Enabling Zone 7
SIR DISABLING AND ENABLING ZONE 7
DISABLING PROCEDURE
1. Turn the steering wheel until the vehicle wheels are pointing straight ahead.
IMPORTANT: Refer to SIR Disabling and Enabling Zones before disabling the SIR system.
2. Turn OFF the ignition.
3. Remove the key from the ignition.
